Geometries Suitable for 3-Axis Machining
In 3-axis CNC milling, linear movement between the tool and workpiece is planned along X, Y and Z. Flat faces, open pockets, slots and holes accessible from suitable directions can be considered for this approach. A prismatic part’s suitability depends on more than its overall size. The cutter must reach the feature, the holder must clear surrounding surfaces and the component must be held securely.
| Geometry | Detail to review | Possible planning requirement |
|---|---|---|
| Open pocket | Depth and internal corner | Tool access |
| Side hole | Hole direction and reference | Repositioning |
| Thin wall | Surfaces that can be supported | Workholding approach |
| Multiple machining faces | Shared datums | Operation and inspection sequence |
Tool Access and Reclamping
Deep, narrow pockets, small internal corners and tall walls may restrict tool access. If a face to be machined is also needed for workholding, the operation sequence requires particular attention. Where features machined after turning the part have positional requirements relative to one another, reference transfer is reviewed. Identifying machining faces early allows stock form and workholding to be considered within the same plan.
- Can the tool reach the pocket floor and walls?
- Can workholding surfaces remain available for later operations?
- Do features on different faces share the same datums?
Assessing Economic Suitability
Information Needed for a 3-Axis Milling Enquiry
Frequently Asked Questions
Is every prismatic part suitable for 3-axis milling?
Suitability depends on tool access and workholding. Undercuts, surfaces facing different directions and enclosed areas require separate assessment. The decision is based on the technical drawing and any available model.
Does turning the part over prevent 3-axis machining?
No. Reclamping can be planned to machine different faces. However, reference transfer, positional relationships between critical features and workholding surfaces must be reviewed for each setup. These steps affect the scope and preparation needed.
Which information affects the cost of 3-axis milling?
Material, quantity, pocket depth, tool access, tolerances and the required number of setups are assessed together. Overall component dimensions alone do not explain the cost scope. A current drawing and a clear quantity support quotation review.
